Nanyang Senba Optical Electronic Co., Ltd.
Main products:PIR Sensor, LDR Sensor, Module
Products
Contact Us
  • Contact Person : Ms. -Power Eagle
  • Company Name : Nanyang Senba Optical Electronic Co., Ltd.
  • Tel : 86-755-82594732
  • Fax : 86-755-82594727
  • Address : Guangdong,Shenzhen,No.4 Building, Huawan Industry Area,BaoAn,ShenZhen,China
  • Country/Region : China
  • Zip : 518100

pir sensor switch supplier

pir sensor switch supplier
Product Detailed
pir sensor switch supplier on celling 360 degree: round cover high sensitve load power 800W consumption less than 0.02

pir sensor switch supplier

 

Intelligent infrared sensor switch is pyroelectric infrared sensors, daylight detection sensor, High sensitivity andreliability.This switch is especially suitable for classrooms, schools, libraries, offices, hospitals, computer room,

 

meeting rooms and other public places.

 

pir sensor switch supplier Features:

 

1.auto-sensing, entering the region, the lights, leaves auto delay off.

2.during each effective, human activities will cause a delay sensing switch automatically extended time period.

3.Adjustable light intensity: adjustable CDS.

4.Delaytime adjustable.

pir sensor switch supplier Technical parameters:

 

1.Operating voltage: 110VAC or 220VAC.

2.sensing distance: the largest mounted side wall 7 meters (adjustable).

3.Load type: fluorescent, LED energy saving lamps, all kinds of lamps.

4.Power consumption: < 0.25W

5.Load power: < 600W

6.Detection angle:110 --- 140 degrees

7.Open the light intensity setting range :1-250LUX (adjustable)

8.Output Delay: 30 seconds --- 30 minute (adjustable)

9.Ambient temperature: -10 ~ +50 °C

10.Product Size: φ95 × 35mm

11.Contact the working life: 50 million

 

pir sensor switch supplier Instructions for use:

 

1. according diagram connected switch, power warm-up time about 2 minutes. After warm-up, the switch enter

normal operation. When daylights, the switch automatically closed.

 

pir sensor switch supplier Use Note:

 

1.Wiring installation shall not be charged, non-load short-circuit, to be installed after the power.

2.Strict accordance with the wiring diagram wiring, if a wrong can damage the switch, resulting in power line fault.

3.Prohibited use of super-power range, otherwise it will burn switch.

4.Installation environment: switch installation location as possible from the load is greater than 1 meter, not the

switch installed in direct sunlight or air flow areas. Switch can not be placed where there are high-power radio

frequency radiation (example: radio, radio, the antenna).

pir sensor switch supplier



Copyright Notice @ 2008-2012 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.